Allparts Stratocaster maple neck SRO-62 rosewood fingerboard veneer

Allparts Stratocaster maple neck SRO-62 rosewood fingerboard veneer

All Allparts branded Fender Licensed Stratocaster necks are made of the highest quality maple and rosewood , neck made in USA or Japan. All sleeves cannot be exactly the same, the images are indicative. Each neck may vary slightly from the illustration.

Stratocaster Allparts SRO-62 neck fingerboard veneer

• Allparts Stratocaster Vintage SRO-62 maple neck rosewood fingerboard "veneer" glued to the radius of the maple, thin rosewood blade cut on edge and glued curved as it was done in the 60s;
• SRO-62 neck: 21 vintage frets, aged white fingerboard markers in slightly aged phenolic resin;
• Allparts Stratocaster Neck Licensed Fender Reproduction, 1959/1960 Style Small and Thin neck Neck;
• Very thin and symmetrical C-profile, 7.25" vintage radius;
• Raw handle to be prepared and varnished;
• The neck features a single action trussrod with no skunk stripe on the back.

All Stratocaster Allparts have a limited warranty against defects in materials and workmanship. The warranty does not cover normal fret wear or customer modifications. This neck is licensed to Allparts Music Corporation by Fender® Musical Instruments under trademark license.

Allparts Music Corporation is not affiliated with Fender® and no Fender® warranty applies. All brand new licensed raw necks may require upgrading the frets, these are parts of the tonewood that may need to be adjusted to suit the body of your instrument. This is normal, it is not a defect. All sleeves must be carefully inspected before assembly and modification.

Characteristics " Allparts Stratocaster Rosewood veneer neck SRO-62":

• Thin symmetrical C-type neck profile and narrow at the nut;
• Channel delivered without nut;
• Allparts SRO-62 maple neck rosewood veneer;
• Neck neck : 0.85" at first fret, 0.95" at twelfth fret (thinnest in SRO lineup).
• 21 vintage thin frets (.079" x .051");
• Fingerboard Radius: 7.25";
• Nut Width: 1-5/8" (41.8mm);
• Heel Width 2-3/16" (56mm);
• Tuning machine head tuners Hole Diameter: .340" (8.6mm);
• Trussrod Phillips screw adjustment at heel.