Fender Telecaster Plus 1993 TBX tone control circuit Assembled

Fender Telecaster Plus 1993 TBX tone control circuit Assembled

Fender Assembly circuit plate Telecaster Plus 1993 TBX tone control. Standard Telecaster Plus controller circuit, compatible with all Telecaster single pickups of any brand. CRL USA 3 position selector switch, CTS 250K master volume and TBX tone for all positions. Fender's TBX Tone Control provides mid-range brilliance and cut when needed.

Fender Assembly circuit board Telecaster Plus 1993 TBX tone control

• Mid/treble frequency control and cutoff, the TBX is a high pass/low pass filter. This passive electronic potentiometer offers accentuated control of the tones, in the central position the potentiometer "clicks" and is placed in "No load" mode so the sound of the microphones goes directly to the amp outside the tone circuit and therefore without additional resistance ;
• Turned clockwise, the TBX brings a particular brilliance and a balanced punch for the mids/trebles. Turned in the opposite direction, it cuts all high frequencies to leave round and powerful lows, ideal for reproducing an overdriven broadcaster sound ;
• Wired TBX with .022ufd/250V red Mylard capacitors, 180pf resistor, 250K/1Meg stepped potentiometer, all circuitry and mounted with vintage USA AWG 22 push-back single strand copper wire, switchcraft usa jack header , assembly drawing provided ;
• The TBX and a passive mid-treble controller knob mounted as standard on the Strat Plus, Telecaster Plus and Eric Clapton Stratocaster, but also on the Strat Standard USA produced in the 90's in HSS mode.

Plate model mounted in series since 1988 to 1996 on the Telecaster Plus and Ultra or Custom Shop in the 90's. Usually mounted with 2 or 3 single Lace Sensor Fender Gold and Red pickups.